In reading some of the posts on this forum I noticed that a quite a few people use 65-80# PowerPro or some similar type line on their reels and then use a lighter mono or flouro-carbon leader attached to the swivel. Is there any particular reason why you opt to use this rigging instead of using the same line you have spooled on the reel?? The only reason I can come up with is visibility and I can't see that an issue night fishing.
-------------------- GOD MADE MAN BEFORE WOMAN SO AS TO GIVE HIM TIME TO THINK OF AN ANSWER FOR HER FIRST QUESTION
The idea of using a slightly lighter mono leader Jim is for abrasion resistance and to a lesser extent, saving the swivel and the sinker by breaking off before the main line does.
-------------------- Briank's Trophy Catfishing and Sturgeon Adventures
'09 Photo's<<
I figure they're trying to tie an excuse into their rigging - why else would you go to the trouble of having super-strong, expensive line, strong swivels, sharp and stout hooks, then give yourself a weak spot by using weaker line where it counts the most?
Everyone has a preferred way. I like Matt use the "no weak link" method.
My thought regarding abrasion is that I should be checking my PowerPro each cast/rebaiting. Also the area the sinker slides up and down. Generally, this two to three foot section is cut off every couple three trips out.
-------------------- Briank's Trophy Catfishing and Sturgeon Adventures
'09 Photo's<<
Matt hit this one on the nose. I use a short 30lb mono for my channel cat rigs because I find it easier to switch them on my channel cat rigs. Hooks often get broken or badly bent but for big flatties, I'd not use it.
line-leader question
